Beretta.net

I finally did the rear disc swap on my 90 GTZ, and wow what a difference! Even with the stock fronts, (except for drilled and slotted rotors) I got the brackets from the JBody.org group buy(3/8th inch spacing), AC delco SRT4 rear rotors, and new Saturn SC2 rear calipers, caliper brackets and pads. O...

I'll take the carpet, carpet stays and sail panels off your hands at BFest

this will help as well

Hopefully this will help you

CIRCUIT DESCRIPTION : The ECM has two injector driver circuits, each of which controls a pair of injectors (1 and 4 or 2 and 3), although all are pulsed at the same time (simultaneous injection). The ECM monitors the current in each driver circuit by measuring voltage drop through a fixed resistor a...

second pic

Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » Manufacturer Code Charts » DTC 65 » Part 1 of 2 PART 1 OF 2 Code 65 (Part 1 Of 2) Code 65 Wiring Diagram CIRCUIT DESCRIPTION : The ECM has two injector driver circuits, each of which controls a pair of injectors (1 and 4 or ...

I'm payed for in full on this! I can't wait

When I lowered my GTZ with Canuck springs, I use new everything. Strut mounts, struts, shocks, spring seats, bellows. I used Monroe sensitrack struts, and they are fine, even after over 60k on the car. And Canucks are lower than Eibachs

Knock sensors are on the back of the motor under the exhaust manifold. I took my manifold off to replace mine. Its a one wire round connector. Is that the sensor you're talking about?

You have one of three problems, a weak compressor, A dirty condensor, or you fan is not working

Well, she's running but I may have to pull the engine out... She's got a bad oil leak right where the cam towers meet the timing cover. No, it doesn't REQUIRE pulling it, but I think it may be a hell of a lot easier than trying to wrestle everything aside in the car. Oh, and my supposed HO injector...

Our fog lights are grounded by the fog light housing. Should be grounded by the clip that holds the bulb in the lamp. If the housing or retaining clips are rusty it will not ground due to high resistance. Are yours rusty? Clean them off and see if they work.

Ey guys i'm looking for a Z04 spoiler or a trunk lid without a spoiler. Black if possible, in good shape is a must.

Can anyone tell me if this is a low output motor in my car by the intake it looks to be cause I compared to a high output pic of one I have and what years had the sensor in the oil pan cause this one has that please let me know thanks Your motor is a 95 Low output motor. you can tell by the timing ...