Beretta.net

Haha thats true! Didnt even notice they were the same! Well if thats not right...dont use either measurements. Im not sure if there are original, drivers side sticker is not even layed straight. Lol.

Fyi..I didnt change any stickers on the car. Thats how it came when I bought it. Obviously, car is almost 20yrs old somebody must of messed with it.


Edit: size is 2 1/8" x 11"

They are originals I can tell that because they are printed on clear vinyl... So at least get me the size of it... that will be the door size I make.

How's this? I realize my sheet wasn't long enough for the door one, but it shows the angle pretty good...

so bumper is 7 1/4 x 1 5/16

And the door is 11 ? X 2

Whats the width of the door one? just measure it and tell me the number that works too.

The top edge of the decal measures 10 5/8 including the clear border. So it looks like total width would be approximately 11 3/8".

Also, I did double check that printed sheet that I used with a ruler to verify it wasn't scaled.

how wide is the clear border? safe to say tip to tip its 11 1/8?

1/8" border outline?

Yeah, it looks to be about 1/16". It definitely gave them some leeway in production...

2 x 11.25 for the door, then scaled down 65% gets me 1.3 x 7.3125 for the bumper.

That close enough for everyone? LOL And just do an 1/16" border on them.

Measurements sound good.

Ill be needing a set soon, right after I send off my car for the new paint job.

Hey Cliff your green was printed out of registration for the rear bumper. Factory defect must be worth millions!

why don't you buy a set? Like they are pricey?

the OEM decals have lineup marks for proper install.

Jon I am going to be with Rodney all day tomorrow at CSCS and his car (The one I bought off Jim in California) is 100% original paint, decals, everything..

I will take a dozen pics and get someone to figure out how to send them to you asap.

I even know how to work a tape measure. LOL!

It's the best "on the car pics" you might get.

ErichZ26 wrote:why don't you buy a set? Like they are pricey?

the OEM decals have lineup marks for proper install.

I'm gathering artwork for all the other decals so what does it hurt to have this all setup and planned out? If someone want's to buy them from GM so be it... if they have what they are looking for great... If not like many other decals then we have the ability to re-produce. Why so negative?

Going to the shop today to talk over some details on the GTU stuff and Z26 stuff. I need GTZ dimensions!

I was hoping to make it up to Tyler's over the weekend but didn't get a chance to because people backed out.

This weekend I'm going up there no matter what. If you still need the rear bumper decal dimensions I can do that.

Can't wait to get the decals made that I posted on Fb lol.

Sent from my EVO LTE using Tapatalk 2