Page 3 of 3

Re: Z51 sway bar aftermarket bushing?

Posted: Tue Jan 07, 2014 5:42 pm
by Slinky
Ok the one i previously ordered and sanded the bottoms down on that are to skinny are the ones in the following link
http://www.energysuspensionparts.com/pr ... od=16.5108

The next link are the ones listed for the z51 sway bar but are sloppy in the brackets and are 19mm
http://www.energysuspensionparts.com/pr ... rod=3.5169

I'm to the point now where I would pretty much almost by used rubber bushings from someone just so I don't pay an arm and a leg and I know they will fit..
Anybody got some stock ones they wanu sell??? :D

But i think i may order these to see if they fit but i doubt it..
http://www.energysuspensionparts.com/pr ... rod=9.5126

Re: Z51 sway bar aftermarket bushing?

Posted: Wed Jan 08, 2014 10:21 am
by 3X00-Modified
Dimensions are right on that page... don't waste the money if it doesn't measure up. 1 3/16 wide for where I'm assuming the lip would start... and a rough height of the bushing including that universal bracket is 1 3/8"

Image

ES has all of these dimensions called out for their universal bushings so if you use their catalog you should be able to find the best bushing and I think 22mm ID will be too loose on the bar.

Re: Z51 sway bar aftermarket bushing?

Posted: Wed Jan 08, 2014 12:31 pm
by Slinky
I noticed that on the energy suspension sit and compaired and i felt the same way, im not going to waste any of my money, i ordered 2 new gm ones and my brackets came with one, but i am still 1 short

Re: Z51 sway bar aftermarket bushing?

Posted: Wed Jan 08, 2014 2:17 pm
by 1988GTU
Slinky wrote:Ok the one i previously ordered and sanded the bottoms down on that are to skinny are the ones in the following link
http://www.energysuspensionparts.com/pr ... od=16.5108

The next link are the ones listed for the z51 sway bar but are sloppy in the brackets and are 19mm
http://www.energysuspensionparts.com/pr ... rod=3.5169

I'm to the point now where I would pretty much almost by used rubber bushings from someone just so I don't pay an arm and a leg and I know they will fit..
Anybody got some stock ones they wanu sell??? :D

But i think i may order these to see if they fit but i doubt it..
http://www.energysuspensionparts.com/pr ... rod=9.5126
Have you looked at my links?

Re: Z51 sway bar aftermarket bushing?

Posted: Wed Jan 08, 2014 2:47 pm
by Slinky
Yeah but im pretty much out of time, if they are "universal" like the ones i have there is a great doubt they will fit and i checked what Jon had posted and none o them have proper dims listed to fit in the brackets.. So im on the search for 1 stock bushing..