Beretta.net

Posted: **Fri Apr 20, 2007 3:35 pm**

CHECK THIS OUT.
i want to build a custom box of 2-15's
but when your are inside of the car{you and 1 friend}

you can see inside of the trunk thru tha bacc seat!
tha bottom of tha bacc seat wil be fabricated so you can sit down.

but should i have tha fiber glass bacc seat rest fold up and down/
or have tha middle of tha bacc rests fiberglassed and the outside fabricated.
and in tha box{trunk} im goin to have a pulsing light so you see tha subs and amps

Posted: **Fri Apr 20, 2007 5:30 pm**

You could go find a set of rear folding seats and solve both those problems. And the grammar and spelling is so bad I'm not even going to attempt to figure out what your trying to do.

Posted: **Mon Apr 23, 2007 10:52 am**

ok i could
it will be like my old beretta

but do you think the subs will beat harder if the whole trunk is a box,
or if i had a regular box turned to the bacc with the baccseats down

Posted: **Mon Apr 23, 2007 4:42 pm**

Build a box to the dimensions needed for the sub. The owners manual for the sub will tell you what size and sometimes what design is best. Then put that as far back in your trunk as you can go. Closer to the taillights. If you have rear folding seats and put them down they will be louder because the air can travel right on through.