Page 1 of 1

Need help in Chambersburg, PA

Posted: Mon Feb 20, 2017 10:43 pm
by bmroyer
I started replacing my clutch in my 1989 Beretta GT 6 years ago, mostly because I couldn't find the parts like the clutch fork. The clutch is replaced and the tranny is attached, but I am unsure how everything goes under the hood as it has been so long ago. Any help would be appreciated! Willing to pay reasonable fee.

Re: Need help in Chambersburg, PA

Posted: Thu Feb 23, 2017 3:30 pm
by GT_Indy
What specifically do you need help with?
If you post photos it could help us to direct you with what goes where.

Re: Need help in Chambersburg, PA

Posted: Fri Feb 24, 2017 8:22 am
by bmroyer
Here are some pictures. Basically I have the shifter hooked up, now I need to hook the clutch pedal and that stupid finger thing that I can't get back on.

Re: Need help in Chambersburg, PA

Posted: Fri Feb 24, 2017 10:17 am
by bmroyer
How do I secure the shifter cables? Can't seem to get the thing in neutral.

Re: Need help in Chambersburg, PA

Posted: Fri Feb 24, 2017 4:46 pm
by GT_Indy
bmroyer wrote:How do I secure the shifter cables? Can't seem to get the thing in neutral.


Try lifting the front wheels off the ground with a jack so they can rotate freely, then you should be able to take it out of gear without the clutch being pressed.

That slave cylinder needs to be compressed (Pushed fully in) to get that clutch fork finger thing back on the clutch fork, it is keyed and only goes on 1 way. Might be easier to remove the slave cylinder then install that on the end of the clutch fork, then put the slave back.

Just to note, If there is any air at all in the slave/master/lines it will not work properly at all.
When I had mine, I had to bench/gravity bleed it for a while before I finally got all the air out, and I carefully strung it back into the car in 1 piece.

Re: Need help in Chambersburg, PA

Posted: Sat Feb 25, 2017 3:40 am
by Cliff8928
Looks like you're missing the bracket that the shift cables attach to.

Re: Need help in Chambersburg, PA

Posted: Sat Feb 25, 2017 5:02 pm
by bmroyer
Does anyone have a referral picture to see what this bracket looks like?

Re: Need help in Chambersburg, PA

Posted: Sat Feb 25, 2017 6:41 pm
by ifixalot
from the 1990 service manual, hope they help.