Page 2 of 2
Re: Project 91 GTZ Build Thread
Posted: Wed May 23, 2018 5:57 pm
by Rettax3
Okay, now that the Photo-Bucket pics are here, I can see what you have...
- Front pax-side mount is here.
- This is a stock 2.8/3.1 MPFI mount...
So you have an old 3.1 MPFI block then? The 3400s (and 'M' code and 'J' code 3100s too) were lacking the mount bosses to bolt this style mount to the block. Unless there is some hidden adapter behind it that I can't see, this is a positive identifier for your engine as an MPFI block. I thought yours was newer... So it has a 3400 top-end bolted to a 3.1? Funny, that is the direct opposite of what my '90 'Retta has -a 3400 block with a Turbo 3.1 MPFI top-end!
I love GM's swap-ability!
Re: Project 91 GTZ Build Thread
Posted: Wed Jun 06, 2018 1:50 pm
by banzai92gt
Silly photobucket.
Chris88CL built the motor YEARS ago so my knowledge of it is limited.
So I have those 2 mounts, plus the one that attaches to the top of the Tranny, just need the 5 spd bracket instead of the auto bracket? and i need to modify the dog bone?
Re: Project 91 GTZ Build Thread
Posted: Sat Jun 16, 2018 3:06 pm
by MY91GT(Z)
I have upper bracket if thats what u need
Re: Project 91 GTZ Build Thread
Posted: Sun Jun 17, 2018 8:41 am
by woody90gtz
Hmm. Internal slave was mounted differently in Berettas from the factory. Does it have the two mounting bosses at the top of the bell housing that are needed for the old style mounts?
Re: Project 91 GTZ Build Thread
Posted: Wed Jun 20, 2018 6:27 pm
by banzai92gt
Heres the tranny
Re: Project 91 GTZ Build Thread
Posted: Wed Jun 20, 2018 11:35 pm
by woody90gtz
Ok, it does. That trans has provisions for 92+ mounts and the 91-older.
Re: Project 91 GTZ Build Thread
Posted: Thu Jun 21, 2018 11:25 pm
by banzai92gt
Wicked! Thanks for the info man
Re: Project 91 GTZ Build Thread
Posted: Thu Jun 28, 2018 1:31 pm
by banzai92gt
Where does the front passenger side mount, attach to? i might be missing that as well?
car has been apart for well over 5 years now.