TURBO 2.2 QUESTIONS

Keep this to general Beretta/Board/Community topics.
Post Reply
Dostom
Registered User
Posts: 12
Joined: Sat Apr 22, 2017 7:07 pm

TURBO 2.2 QUESTIONS

Post by Dostom »

In the next couple of months I'm going turbo
I'm running an external wastegate, small turbo set at about 7psi. I'm going to be using AutoProm to street tune then later on dyno tune the car
My question is about the intake manifold and injectors
I was looking into doing a 98+ cavalier intake manifold and fuel rail, what plenum spacer would I need to make it all fit? Also would there be any advantage to putting a distribution block from an 03 ?
Would it all bolt in and be plug and play?
Im OBD1(1995)


Oki_Hero
Registered User
Posts: 95
Joined: Mon Jun 06, 2016 10:20 pm
Location: Ettrick,Va

Re: TURBO 2.2 QUESTIONS

Post by Oki_Hero »

I can't answer all of those question and there isn't a lot of people running the 2.2 (though I am in the process of trying to building a NA 2.2). JBO is a better source for a 2.2 build. Also check out chevy cavalier world prices are a bit steep but I know they make an adapter plate to run a 98+ TB and IM


96 Corsica 2.2 3 speed auto (awaiting building)
Post Reply