Center console question

Archived topics from the Other Tech Questions Forum
Guest

Center console question

Postby Guest » Sat Mar 08, 2003 11:55 pm

Does anyone know the easiest way to take off the shifter knob on an automatic? I also want to take my shifter plate that is on the center console off to really clean it off and adjust the numbers. ( P R N ect) Any advice would be greatly appreciated. Thanks



Guest

Center console question

Postby Guest » Sun Mar 09, 2003 1:07 am

This is an easy one, take a flat head screw driver and look at the front part of the shifter, that faces the radio.  There is a "U" shaped pin holding it in.  Just pop that pin out and lift up, DO NOT TWIST.  Then the other part should pop with a flathead also.

Real easy, should take you under a minute for both, either that or I've spent too much time in the junkyard.







Guest

Center console question

Postby Guest » Sun Mar 09, 2003 1:07 am

OH, by the way.  Put the cars tranny in L, and put the ebrake on.  It will make it easier to see the U pin.



Guest

Center console question

Postby Guest » Sun Mar 09, 2003 9:42 pm

thats a nice car



Guest

Center console question

Postby Guest » Mon Mar 10, 2003 12:38 am

Quote (rollerchicken @ Mar. 08 2003,22:55)
I also want to take my shifter plate that is on the center console off to really clean it off and adjust the numbers. ( P R N ect) Any advice would be greatly appreciated. Thanks

In order to take off the plate part you are talking about, that can be gently pryed off after the shifter knob is removed by using a screw driver.  You'll then have to disconnect the cigarette lighter wiring, trunk release wiring, and the little light (twist and pull) that lights up the (P R D etc.)  Once that's off you flip that piece over and use a tiny phillips to take off the screws that hold the white piece of plastic that protects the (P R D etc) and clean it all up.








Return to “Other Tech Questions Archive”

Who is online

Users browsing this forum: No registered users and 2 guests