Clearing a code...

Archived topics from the Other Tech Questions Forum

Clearing a code...

Postby Guest » Sun Jan 19, 2003 7:08 pm

I have a 94 base 3100 that had the O2 sensor replaced before I bought the car. It went bad and was replaced but the computer still thinks it's bad and trips the "Check Engine" light. I was told that the only way to fix this was to take it to a dealer and it'd cost some good money. Is there any way to get it done cheap?
It isn't a big problem but I'd like to eliminate it. How would I know if the light ever comes on and it's actually legit? Know what I mean? Thanks.

User avatar
Registered User
Posts: 77
Joined: Fri Dec 21, 2001 10:53 pm
Location: San Francisco, CA
Has thanked: 1 time

Clearing a code...

Postby CKr » Sun Jan 19, 2003 8:35 pm

I believe if you take the negative terminal off your battery for 5-10 minutes this will reset the computer.  Although the person who changed the O2 sensor should have disconnected the battery while they were replacing it.

96 BRM Z26, 98 Estoril Blue BMW M3

Return to “Other Tech Questions Archive”

Who is online

Users browsing this forum: No registered users and 1 guest