Beretta 3500 Craigslist $1800

[13's or bust]

Actually i thought about both of thoae, well really jon said the park neutral switch, but its,before 4k itll very seldom go near 4k, usually 3700-3900. Kris it very well could be, i jad to solder the injector clips for the multec 2 injectors.

[ErichZ26]

Its running in limp mode because of some wiring issue.

[13's or bust]

It very well could be going into limp mode, how could i tell? Is there anyway of telling? I have to swap in my newish injectors from jon so ill check the harness to see whats up. Maybe theres a open somewhere?

[3X00-Modified]

Scan it while driving and when this happens as I've been saying from the beginning otherwise your shooting into the dark and wasting money.

[wicked-irocz]

What injectors are currently in the car and what FPR is in the car and what fuel pump is in the car and what is the tune that is on the computer in the car set for?

AND just bring it up and it'll get fixed OR wait for next years BFest or Nitrofest.

[3X00-Modified]

Dusty, all if that is covered... Its apparently a new pump, new filter, I can not verify that since I didn't install them, but it has a 55PSI regulator tested, and also I sent him 22lb injectors and the ECU is set for that, No idea if they are installed yet or not but there were supposed to be 22lb ones in there already. The only tune I have on it is a 3500 VE table and 3500 spark tables and then DHP1.5 trans tables, I left off the 3500 MAF tables since the sensor's are completely different and read differently.

The car if in 100% correct mechanical shape should not be running like this with that tune.

[wicked-irocz]

Thats why I asked Jon is that the other Jon said he hadn't installed them yet. No matter what though, it shouldn't take much to figure out

[3X00-Modified]

Yeah to my knowledge the injectors in there are the same i sent to him just mine may be cleaner or all working vs he may have a dirty or bad one.

[13's or bust]

well depending on how jon feels i dont wanna step on any toes, but if dusty is closer i could drive up and get it all situated if you are in fact cool with that dusty? i also have a bunch of parts to install on it, ported uim, tce tb, egr delete, i need to configure a cai, and some type of exhaust to go on the car its open dp currently.