Tranny/Sensor Problem?

Guest · Post by **Guest** » Fri Dec 30, 2005 3:01 pm

Maybe you guys can help me out. I drive a 95 Beretta 3100v6 with an automatic transmission. Once in a while the "SES" light will come on and the car will not shift into high gear on the highway. Also it will wind out farther before it shifts into the other gears. Sometimes when accelerating the car will cut out for a split second. This doesn't happen all the time, but it's starting to happen more frequently than it was. The tranny fluid should be good because it was changed about 35,000 miles ago with Redline synthetic put in it. Could this be the transmission going bad or a solenoid? Your help is greatly appreciated.
Todd E. Reinecker

Guest · Post by **Guest** » Fri Dec 30, 2005 8:08 pm

check wire connector at harness to transmission.

Guest · Post by **Guest** » Fri Dec 30, 2005 8:22 pm

thanks for the suggestion. where is that connector located?

cramez · Post by **cramez** » Sat Dec 31, 2005 1:43 pm

Get the codes scanned and figure out what is kicking the SES light on. You'd be amazed how often something small and stupid can cause the whole problem.

Connect with your social network account