Ignition key switch
-
- Registered User
- Posts: 8
- Joined: Tue May 17, 2011 4:24 pm
- Location: Yuma, Arizona
Ignition key switch
Can anybody tell me how to change an ignition key switch on a 95 without tilt steering?
-
- Global Moderator
- Posts: 1991
- Joined: Sun Nov 03, 2002 4:10 pm
- Location: Concord, NC
- Contact:
Re: Ignition key switch
I changed one in a 91 w/ tilt once.
It was years ago, but from what I remember, I had to remove the airbag, the steering wheel, the locking plate behind the steering wheel. Then you could get access to the ignition cylinder. I don't remember much else than that; I don't remember if you have to drop the column or not.
It was years ago, but from what I remember, I had to remove the airbag, the steering wheel, the locking plate behind the steering wheel. Then you could get access to the ignition cylinder. I don't remember much else than that; I don't remember if you have to drop the column or not.
Geoff
95 Z26 Turbo 3400 5spd - R&D Project
Beretta Preservation Society - Director of Acquisitions
95 Z26 Turbo 3400 5spd - R&D Project
Beretta Preservation Society - Director of Acquisitions
Re: Ignition key switch
no tilt? swap in a tilt column!
1990 Beretta GTZ 1995 Beretta Z26 1996 Beretta Z26
-
- Registered User
- Posts: 8
- Joined: Tue May 17, 2011 4:24 pm
- Location: Yuma, Arizona
Re: Ignition key switch
This may sound wierd but, I've found that the steering wheel is actually at the perfect angle for me. I really don't need tilt steering.
-
- Registered User
- Posts: 8
- Joined: Tue May 17, 2011 4:24 pm
- Location: Yuma, Arizona
-
- Registered User
- Posts: 8
- Joined: Tue May 17, 2011 4:24 pm
- Location: Yuma, Arizona