Beretta.net

it's the clutch disc, happened to me twice on one gtz, and now on a second
car. starts off with you have a hard time geting it into first at a light, to not
geting it in at all after time.

anyone know where i can find a fiberglass ram air hood for a beretta ? the one im looking for has 2 scoops and looks like a late model trans am. found one place in canada, but it is lift off only and high shipping cost. any one know where else i could find one ?                                      ...

ok, pulled crank position sensor out last night, and noticed the target wheel is off to one side of the sensor hole (sensor only over little more than half the target wheel) the book said the target wheel is CAST into the crank so i know it did not slip over. any one know if this is the correct posi...

could this be the crank position sensor getting weak ?
if its starting to go out could it possibly see a stronger
target on the crankshaft ? is there a seperate target
for cyl. # 1&4 and cyl. # 2&3 ?

My 1990 gtz is doing the same thing, it started with the car missing when it was cold, and go away when it was warm, and every once in a while warm at a stop light it would miss and go away at 2000 rpm. now, cyl. #1&4 will not fire. swaped coil packs, put in new plugs and new ign. module, but cy...

I have a 1990 gtz that will not pass smog. nox way too high, due to high combustion temp. egr takes care of this, but the 2.3l engine has no egr. any body know how the nox is controlled on this engine ?
PLEASE HELP !
no smog no gtz
                                                      THANKS

i have a 1990 gtz, and the engine and clutch were installed new two years ago. now the clutch will not release compleatly when pressing the petal to the floor. i can not get the car in gear when started, i must stop the engine then put it into gear and still feel the car creep foward when started. i...