slave cylinder

[paananen]

do i have to take the bell housing off to change the internal slave cylinder or is there anything special i have to do.i have a 1995, 2.2 liter engine,5 speed tranny.thanks

[heavywoody]

You have to remove the transmission to change the internal slave cylinder... it goes around the input shaft of the trans, which goes through your pressure plate/clutch disk and into your crank.

[paananen]

hi is there any way to check the slave cylinder for a leak without removing the transmission.thanks

[Cliff8928]

There would be clutch fluid dripping from the transmission.