O ring for Tube

[Money pit Beretta]

I used an injector O-ring soaked in gas for the LIM. No leaks so far and it was free. No parts stores had it in my area if that makes you feel better. The size that is close in the kit wasn't the right one. Well, I did get and O-ring for the water pump housing from the parts store. It fits very tight and has held up well. I think it was rubber though. Hope mine hold out, I may need those part numbers if they don't. Save them 1988GTU, you may get a PM from me.
I did write them down, but could lose it.

[1988GTU]

lol ok. I think I am in the same boat as you with keeping that info around longer than a week.

[Money pit Beretta]

Getting old and the mind is gone(lol). That and I think that I'll remember which toipc the info is in, that is not so. I do try the seach, but that sometimes doesn't help. I use to remember everything!