Base model to a GTZ??

96B-Mike · Post by **96B-Mike** » Wed Jan 19, 2011 9:52 pm

So i went to the junkyard and i found a ('92 i think) GTZ

so i took the front and rear bumper..my question is- Is there any need of parts that is a must need to grab off of the gtz or should i be prepare for any modifications??

Chad91GTZ · Post by **Chad91GTZ** » Wed Jan 19, 2011 10:26 pm

the side skirts come to mind

96B-Mike · Post by **96B-Mike** » Thu Jan 20, 2011 12:29 am

oh i know but i was unable to get em atm

Post by **3X00-Modified** » Thu Jan 20, 2011 8:49 am

the whole radiator shrouding that directs air from the lip entrance up to the radiator. It's vital if you plan on using a solid grill.

Also wouldnt be a bad idea to get the parking lights and fog assy, as well as the lighting wiring harness from the bulkhead forward, but you'll have to add one extra wire inside for the fogs, OR you will have to splice into that feed under the hood to operate them.

I added the wire to the bulkhead when I had my dash out so I could use the factory Z26 light switch.

90GTZHO · Post by **90GTZHO** » Fri Jan 21, 2011 11:13 am

make sure for the rear bumpers, you get the steel rods that support the lower part of the skirt right behind the wheels. Also, did you grab the plastic covers that sit under the bumper to keep the water and crap out from under the car? I think the fender liner is also different between the base and the GTZ models but dont quote me on that.

Post by **3X00-Modified** » Fri Jan 21, 2011 1:10 pm

Fender liner is the same, but you do need the lower plastic parts for the front half of the bumper, as well as the lower scraper that bolts to below the radiator support.

Chad91GTZ · Post by **Chad91GTZ** » Fri Jan 21, 2011 1:41 pm

Basically you need all the plastic crap you had to remove to get the bumper off.

96B-Mike · Post by **96B-Mike** » Sun Jan 23, 2011 4:32 pm

yeah i got everything besides the fog lights

dhenderz · Post by **dhenderz** » Sun Jan 23, 2011 9:12 pm

OK, so stupid question. Are you trying to make a car look like a GTZ, or handle/perform like a GTZ? Those 2 goals require an entirely different set of parts from the donar car. All of the responses in this thread are aimed at the 'looking' like a GTZ goal, minus the obvious - seats.

If you want a car that performs like a GTZ, then you have a totally different set of parts to get.

96B-Mike · Post by **96B-Mike** » Thu Feb 03, 2011 1:04 pm

lol no im just making my car look like a GTZ..and only a moron would think by having exterior parts would make it perform like a GTZ haha

Beretta.net

Base model to a GTZ??

Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Re: Base model to a GTZ??

Connect with your social network account