Beretta.net

I need to go back sometime this month. I'll check. Any certain part you need?

LOLVTEC wrote:What a goddamn shame... I have been longing for a Black Z26 for over a decade... Wtffffffff

That was the thought I had when I saw the '95 Z26 I took the Z04 kit I mentioned in your other thread. I just don't understand why a car like that ends up being junked (this one looks a bit rougher than the one I took parts from though).

Luckymc420 wrote:I need to go back sometime this month. I'll check. Any certain part you need?

Lucky, do you really think that car will still be in the yard, after all this time? I know a couple of yards around me are holding on to cars for a LONG time right now, because scrap prices are so low. They are offering like $75 for passenger cars at one of the local yards -which is ridiculous- because they just can't move the old carcasses. If that car IS still there, I am sure you could get a small shopping-list together here...

I doubt they have that car, but they do seem to always have a Beretta sitting there.

Where is this thing located?
I am interested in the ECM.

Des Moines, Iowa

GHOSTOWLGRID wrote:Where is this thing located?
I am interested in the ECM.

I have a '96 Corsica PCM, if interested. 3100 SFI, Auto/OD trans. PM me if you want it, shoot me a fair offer, it isn't worth a whole lot to me since I have upgraded to the Venture PCM for my '90 'Retta, but I would like to get back what I paid for it plus shipping cost. Flat-rate is what ~$12? I did test it a while back, and after re-pinning my harness for it, it DID run the 3.4 engine in my 'Retta, at least in the driveway (3400 injectors with a turbo setup though, so it wasn't running 'right', obviously).

Does it have both an armrest and a driver's side sun visor?

That car is long gone.