Page 2 of 3
Re: GTU in the junkyard
Posted: Thu Jun 02, 2011 6:41 pm
by DOHC_tuner
speedy wrote:hmm, did you see theres a gtz there? how were the visors?? and if you dont know, gtz visors are very specific, they have a plastic piece that slides out almost like an extension. the rest of the fleet of retta's didnt get them, sucks for them, ha. grey interior im assuming?? also, theres some other things im sure i'll need, just give me time to think...
There was a GTZ there. I did not know that about the visors....Let me know what you need...
Re: GTU in the junkyard
Posted: Thu Jun 02, 2011 8:12 pm
by felixGTU
Does this gtu have the emblem that goes on the dash? the one that says " Beretta GTU" if it does im intrested in that.
Re: GTU in the junkyard
Posted: Fri Jun 03, 2011 2:48 pm
by DOHC_tuner
I will check....I like your sig looks just like the one in the jy
Re: GTU in the junkyard
Posted: Fri Jun 03, 2011 3:20 pm
by 3X00-Modified
I doubt the one in the JY has a hood like the one in his sig...
Re: GTU in the junkyard
Posted: Sat Jun 04, 2011 12:43 am
by Cliff8928
3X00-Modified wrote:I doubt the one in the JY has a hood like the one in his sig...
Or the wheels, or the spoiler.... etc...
Re: GTU in the junkyard
Posted: Sun Jun 05, 2011 2:25 pm
by Styluss
I never noticed anything different about the spoiler in that stock photo...
Re: GTU in the junkyard
Posted: Sun Jun 05, 2011 6:33 pm
by DOHC_tuner
Im confused....looks the same to me.
Wheels, spoiler, and hood.
Re: GTU in the junkyard
Posted: Sun Jun 05, 2011 11:09 pm
by Cliff8928
Styluss wrote:I never noticed anything different about the spoiler in that stock photo...
Just look at a pic of it from the side...
Re: GTU in the junkyard
Posted: Mon Jun 06, 2011 3:22 pm
by Styluss
DOHC_tuner wrote:Im confused....looks the same to me.
Wheels, spoiler, and hood.
Wheels: Have a concave center.
Hood: Has a 1 inch cowl.
Spoiler: Explained above.
That spoiler is SICK! Now, I have to find one... OH KYLE!!!
Re: GTU in the junkyard
Posted: Mon Jun 06, 2011 3:55 pm
by felixGTU
Now why didn't the Beretta have this? The rims look better than my stock GTU. I just could not figure out why. But now that you mention it, I do see it.
Re: GTU in the junkyard
Posted: Mon Jun 06, 2011 6:24 pm
by Styluss
I always get a laugh looking at the second pic. This was used as a dealer promo photo and look at the huge misalignment between the door and the quarter panel!
Re: GTU in the junkyard
Posted: Mon Jun 06, 2011 11:24 pm
by Chad91GTZ
And the empty stud for the antenna just hanging out on the fender. I drive mine around like that too. haha
Re: GTU in the junkyard
Posted: Tue Jun 07, 2011 1:10 am
by Cliff8928
Wow, i just noticed that misaligned belt moulding.
As for the wheels, they would've cost more to make. The spoiler probably would've blocked the CHMSL, and the hood was probably scrapped for cost saving as well. If you blow the pic up, the cowl looks like it is an add-on.
Re: GTU in the junkyard
Posted: Tue Jun 07, 2011 2:06 am
by 2.2H8TA
If you want a spoiler like that... Take a GTU spoiler, put it on, and find a Camaro SS, newer body, not sure of the year, but they have 3 peice spoilers on em'. I bet the peices that go on the rear quarters fit. I have parked my base next to one, and just looked, didn't measure, but it really looks like it'd work. A bit of modifyin' may be needed, kinda like the Z34 spoilers, but I think it's worth it!
Re: GTU in the junkyard
Posted: Tue Jun 07, 2011 2:43 pm
by Styluss
Cliff8928 wrote:The spoiler probably would've blocked the CHMSL
Umm... The spoiler has its own CHMSL