Beretta.net

DONT JUDGE ME!!!

The bottom bolt was missing and it was hitting the block and making bad sounds.



I am looking for the part after the dogbone.  It holds the A Frame and Sway bar mounts.  Its basically goes from front of the engine to the back side.


I am still tryin to get a LSD.  So if any can contact him tell him i have cash. Ha HA

Money pit Beretta you never feed wrong info.  Just tryin to help.

Note: I am moving into my house this tuesday so yeah I doubt I get out there and do anything.

Eh, could happen to anybody. At least you found it.

To use Isaac's dogbone, you remove the stock one and drill a hole to put it in. It will help put the power to the ground and decrease engine rock on hard take offs. Less engine rock=power going the ground harder and faster.

I have a MRZ Dog Bone

[QUOTE]Money pit Beretta you never feed wrong info.  Just tryin to help.  Yea, I'd still like to help in some way if I can. I'm sure that you listed the MRZ, I just didn't remember.

(Z26-T @ May 18 2008,19:17)QUOTETo use Isaac's dogbone, you remove the stock one and drill a hole to put it in. It will help put the power to the ground and decrease engine rock on hard take offs. Less engine rock=power going the ground harder and faster.
Or  you buy my ONLY spare SHORTER dogbone and use the stock mount piece.  Much better solution.

i just spent $132,000 today so I am trying not to spend anymore.  I just moved into my first house.  So I bought a lot of STUFF.

Wow, independently wealthy, or good credit? Pics of the new pad?

Sorry about the MIA. But I have been just havin parties a lot. Ha Ha.  but I will try to get some pictures of the place.  Car Project I have not seen.  I am STILL movin in and buying stuff so really the car project is not moving anywhere fast.  I kept telling myself that Id work on it tom. and I end up drinkin.  So oh well.  People just want to come over and hang out.  I HOPE to be able to do something to it this week even if it is little just to get back into the garage.

That's the way it goes. It will take years to get the party out of you. Get back to work! Dang, now I know what's going on(happy B-Day).

Ok I need some help here.  I am wanting to paint the engine bay.  Anyone have a good website that tells me how.  I mean I dont want to use a paint brush.  I rather spray it on.  I have a gun and have a paint booth somewhat built.  

I am also wanting to here your op. on me putting the engine and tranny all together and then instead on dropping the engine and tranny from the top. I drop the car around the engine and tranny. I think this is how it is done in the factory.

Also needing an LSD STILL!   Tranny is sitting and is ready for the case swap and the LSD.

Hey man just remember to get rid of any rust and use a rust converter. I don't know about dropping the car, I thought they dropped the engine/trans into the car(I could be wrong). I would think that it would be more easy to move the engine with a good hoist and some people to keep it from falling over. It's best to buy a book on how to paint. Where is the LSD?
Eastwood Company has a spray(or quart) of what they call Under Hood Black. It's a acrylic lacquer and can take heat up to 250F. You must use self etching primer or rust encapsulator under it(after the rust converter is used).

yes, easier to put it together then drop the car on it.

Its not hard to paint, mask off what you dont want paint on and go to town after sanding then washing it and letting it dry for a long time.

The paint deal I am takin my time on and doing lots of prep work.  

The LSD well shoot I cant find one.

No LSD, what's going on? That guy still hasn't made any?