Beretta.net

it was yesterday lol but i put the seats shane brought me in my 91 base! talk about some clean z seats!

last night I looked at the obnoxious layer of dust that has accumulated on it since I did not cover it this year in my garage... Boy this will be fun to wash when I finally get my headers back.

I have started the process of laying on some fresh coats of paint for BFest!!!
And then the real fun begins... engine mods.

That thing is going to weigh a ton when your done with that paint... lol

Seat swap.

3X00-Modified wrote:last night I looked at the obnoxious layer of dust that has accumulated on it since I did not cover it this year in my garage... Boy this will be fun to wash when I finally get my headers back.

I have to get mine jetcoated one of these days

3X00-Modified wrote:last night I looked at the obnoxious layer of dust that has accumulated on it since I did not cover it this year in my garage... Boy this will be fun to wash when I finally get my headers back.

I had you beat. I'm sure.

3X00-Modified wrote:That thing is going to weigh a ton when your done with that paint... lol

Once he gets to 5 coats, he will use a tiny tiny hammer and gently tap the corner, which will slowly crack across the car and all fall off. Ready for a new coat of paint!

I changed out my front bumper and passenger fender so now she looks pretty again Took the front grill out to see how it looks, putting it back on lol. Next paycheck I get I'm painting the interior white and blue.

Travelor wrote:

3X00-Modified wrote:That thing is going to weigh a ton when your done with that paint... lol

Once he gets to 5 coats, he will use a tiny tiny hammer and gently tap the corner, which will slowly crack across the car and all fall off. Ready for a new coat of paint!

I sand off at least a cost or two each time I paint. It's more of an out with the old and in with the new type thing.
Stop hatin'!

Filled my mounts with poly and picked up a like new rear louver that I'll probably never install.

88_GTU wrote:Filled my mounts with poly and picked up a like new rear louver that I'll probably never install.

Where did you pick up the fill, and how difficult was it to mix?

The urethane casting compound usually comes from McMaster. They have a few different hardness ratings.

Just keep in mind that most harden in 2 hours, but take a week to fully cure.

Yup, Mcmaster-carr. $36 for the 1lb can. I went with 80A shore to help handle the 3500. It's 2 part and pre measured so you have to use the full can in one try. The 1lb can did the 2 fully stripped mounts in the pic. Not a drop left. Cliff is right, 15 min to harden but 168 hrs to cure.

J

I started painting my interior yesterday gonna try n finish today, decided to go with black and blue instead.