Beretta.net

What i got is a 94 beretta 3100 auto and i lost all my gears no forward or reverse. Any ideas of what could cause this? Tranny oil doent smell burned at all and not losing fluid anywhere. Was wondering if the torque converter could do this? Or if theres any electrically things that could be causing this is there a computer just for the trans some where??

Cable break?

Sent from my EVO LTE using Tapatalk 2

No the linkage and cable is fine sorry forgot to say that.

yes, does/can the car roll when pulled out of park?

Is the linkage properly aligned? You may have it in "D" inside the car but the selector is actually in the middle. If that's not the case then you need to check pressure to the trans to make sure the pump drive didn't snap, and ensure the front electrical plug is connected if that is not plugged in none of the solenoids will work.

Sorry been busy with work and getting the car ready for a race actually found it was the half shalf once i got it in the air. Looked at them before but just didnt see it right away. Sorry but thanks for the answers and your time guys.

thanks for coming back with your findings! that may help others down the road (even if it was something obvious once you looked at things)

FYI you should see the speedo moving in reverse and drive in that case. If the speedo is moving you know the diff housing is turning. If speedo runs only spider gears, splines, or axles could keep you from moving at that point.

Glad you got it fixed