Beretta.net

were would be a good place to get a set of racing seats with 4 point harnest for a decent price. nothing extreme just simple racing seats

The seats themselves will not come with a 4 point harness that is an additional add-on that you will have to look at when it comes to properly mounting the shoulder belts. Regarding seats... nothing is made to fit so you are searching the "universal fit" world so that could be anywhere. Remove the current seat and take measurements of the pan width so you know what to look for, that will be the largest limiting factor.

Not racing seats, but perhaps you would be interested in mine:
http://beretta.net/forum/viewtopic.php?f=13&t=9927

I actually had racing seats in my 95Z and grew to dislike them over time.

A proper harness isn't attached to the seats, its attached to the frame of the car.

Mike Prides Autocross car has a 4 point harness for both front seats. They are attached to a bar bolted across the back seat, and to the floor.

Travelor wrote:Mike Prides Autocross car has a 4 point harness for both front seats. They are attached to a bar bolted across the back seat, and to the floor.

That is the correct way... I do not like it when I see 4 point belts going down at a 45* angle to where the rear seat bolts in... Unless you have a really strong seat back you could hurt yourself worse with it setup that way.

thanks guys i found a set. and i knw there a riite way and roung way to mount belts. im going with the proper way. wouldnt do it any other way.

new seats for the beretta. should look good when finished. ive got red 4point harnest coming for them