Page 1 of 1
Where to get gaskets for blower motor housing?
Posted: Sat Feb 09, 2013 3:22 pm
by DanteGTZ
I'm planning on replacing the blower housing on my GTZ. Where can I find the gaskets that go between it and the firewall?
Re: Where to get gaskets for blower motor housing?
Posted: Sat Feb 09, 2013 6:27 pm
by Asylum
I replaced mine on the '92 GT and don't remember there being a gasket.
Get your arm way in there and get all the crap out!
And you need to "clock it" for the drain and the plug
Throw some sealer on it? Not like you are likely to have to replace it again at this point.
Re: Where to get gaskets for blower motor housing?
Posted: Mon Feb 11, 2013 9:21 am
by 3X00-Modified
The blower housing just use bed cap foam to seal it... Other than that I do not believe there is any special gasket, or if there is/was it's sure to be discontinued.
Re: Where to get gaskets for blower motor housing?
Posted: Mon Feb 11, 2013 9:27 am
by woody90gtz
I used the bed rail foam for mine too.
Re: Where to get gaskets for blower motor housing?
Posted: Mon Feb 11, 2013 8:59 pm
by DanteGTZ
Got a link to this bed rail foam?
Re: Where to get gaskets for blower motor housing?
Posted: Mon Feb 11, 2013 9:41 pm
by woody90gtz
I just grabbed it at the local Napa. Comes in a roll with adhesive and you peel the backer off.