Page 1 of 1
Crankshaft sensor
Posted: Mon May 05, 2008 4:30 pm
by Beretta Z26
Hey everybody workin on my Beretta and I need to replace the crank position sensor but I can't find it. I've got a Haynes book but it really does'nt tell where it is. If somebody can tell me about where this thing is maybe my car will start running again.
Thanx
Crankshaft sensor
Posted: Mon May 05, 2008 5:32 pm
by pimpz26
IIRC, it's behind the crank shaft pulley. Meaning you have to pull the pulley/balancer off to get to it.
Crankshaft sensor
Posted: Tue May 06, 2008 1:36 am
by Cliff8928
There's also one that protrudes into the block on the firewall-side of the engine.
Crankshaft sensor
Posted: Tue May 06, 2008 12:38 pm
by JeffD
the one that'll prevent the car from starting would be the one on the back side of the block, right next to the tranny.
Crankshaft sensor
Posted: Tue May 06, 2008 7:29 pm
by SuzukiGhostRider
Correct. ^
Crankshaft sensor
Posted: Wed May 07, 2008 11:06 am
by Styluss
If you have not found this yet... I have a pic in the hayne's manual I can highlight for you. I had to do this recently and yeah, it was a ***** to find...
Crankshaft sensor
Posted: Tue May 20, 2008 12:41 pm
by 2tone88
It's even more of a ***** to change. Mine broke off in the motor, god what a nightmare
Crankshaft sensor
Posted: Tue May 20, 2008 8:44 pm
by JeffD
yeah, that sucks when they break...
Hows it coming? did you get it out?
Crankshaft sensor
Posted: Tue May 20, 2008 9:32 pm
by SuzukiGhostRider
I have a very high recommendation. PB BLASTER BEFORE you start cranking on it to remove it. And tug GENTLY or you'll be dropping your oil pan to get the remains.... GL.