Page 1 of 1
Thread size/pitch etc needed
Posted: Fri Jul 11, 2008 11:02 pm
by 1988GTU
Does anyone know the specs for the threads on the threaded shaft for the shift knob? I would like them as soon as possible if you know them.
Thread size/pitch etc needed
Posted: Sat Jul 12, 2008 3:06 am
by 1988GTU
Anyone?
Thread size/pitch etc needed
Posted: Sat Jul 12, 2008 9:20 am
by Luckymc420
not sure what your talking about to tell you the truth otherwise Id say yes or no
Thread size/pitch etc needed
Posted: Sat Jul 12, 2008 12:43 pm
by Cliff8928
Well, unfortunately none of the shifters for the Beretta have a threaded shaft...
Thread size/pitch etc needed
Posted: Sat Jul 12, 2008 1:04 pm
by 1988GTU
I know none of the Beretta's have it stock, but if you have done the swap you'd know what shift rod I am refering too.