Page 1 of 2
got-r-done
Posted: Mon Sep 11, 2006 10:16 pm
by woody90gtz
http://www.motortopia.com/album/ssp/p/c ... ngine_swap
Finally got the motor in and running. It's only been sitting in my garage for months now. Added a Tranzgenic CAI, FFP udp and dogbone, poly insert while I was at it.
got-r-done
Posted: Mon Sep 11, 2006 11:05 pm
by rweatherford
Sweet! Nice colors.
got-r-done
Posted: Sun Sep 17, 2006 8:40 pm
by woody90gtz
Track time!!!
My best run (#3)
Temp: 75.2, Headwind: 6mph
R/T: 0.357
60ft: 2.253
330ft: 6.382
660ft MPH: 71.70
660ft: 9.832
1000ft: 12.778
1/4mi MPH: 90.15
1/4mi: 15.266
Winner! 1.966
run #2
Temp: 74.3, Crosswind: 3mph
R/T: 0.178
60ft: 2.267
330ft: 6.414
660ft MPH: 71.44
660ft: 9.871
1000ft: 12.819
1/4mi MPH: 90.16
1/4mi: 15.303
Loser! -3.136
run #1 bounced off the rev limiter at the top of 2nd
Temp: 73.4, Headwind: 8mph
R/T: 0.483
60ft: 2.250
330ft: 6.430
660ft MPH: 70.68
660ft: 9.923
1000ft: 12.908
1/4mi MPH: 89.03
1/4mi: 15.427
Winner! 2.160
got-r-done
Posted: Sun Sep 17, 2006 10:33 pm
by 1988GTU
Sweet, now 5 Speed it!
got-r-done
Posted: Mon Sep 18, 2006 10:14 am
by Chazzman
Nice times.....
got-r-done
Posted: Tue Sep 19, 2006 12:18 am
by woody90gtz
got-r-done
Posted: Tue Sep 19, 2006 9:46 pm
by wicked-irocz
yeah, glad it got done. Those are good times for that setup.
got-r-done
Posted: Sun Oct 22, 2006 6:30 pm
by woody90gtz
10-20-06 at Lebanon Valley Dragway.
BAR: 29.34, Temp: 51.8, Wind: 2mph tailwind
(full tank of gas, minor weight redution, cutout open)
R/T: 0.199
60ft: 2.222
330ft: 6.286
1/8mi: 9.648
MPH: 73.40
1000ft: 12.517
1/4mi: 14.940
MPH: 92.52
got-r-done
Posted: Sun Oct 22, 2006 7:05 pm
by Obsessedw/Berettas
Into the 14s with just one swap. Sweet man.
got-r-done
Posted: Mon Oct 23, 2006 6:13 pm
by wicked-irocz
from the other post you made about this:
holy cow. a 14.9 with a z26 3400 stock trans
thats dang good, I think its about time for me to update my list.
how did you prepare your car?
got-r-done
Posted: Mon Oct 23, 2006 8:51 pm
by woody90gtz
I have a 3400 rear manifold and 2.5" downpipe going out a 2.5" cutout before the cat. The cutout gained me 2mph.
The best I could ever run would probably be a low 14.8 with a 1/4 tank and a better launch. My best 60' of the day was 2.17 on a 15.01 run, bouncing off the rev limiter on the 1-2 shift in D.
I also took advantage of my interior redecorating finding my water leak. My damn carpet was probably 100lbs. That thing was soaked, much more than I realized. All my runs this weekend were minus pass, back seat & carpet.
got-r-done
Posted: Tue Oct 24, 2006 12:05 am
by scannerman
way to go woodie
got-r-done
Posted: Thu Oct 26, 2006 3:01 am
by Cliff8928
Good luck with keeping the 3400 manifold downpipe flange intact.  It may be better with an auto because it sits an inch farther forward, but on mine i could NEVER keep a gasket good in that flange for more than 2 days.  That's why I'm getting the headers (which will be here soon!)
got-r-done
Posted: Thu Oct 26, 2006 2:35 pm
by Guest
Bet your tires give quite a smoke show. Try a set of drag radials. It'll also bring down your 60ft time. But then you have to be careful not to break an axel!
got-r-done
Posted: Thu Oct 26, 2006 11:47 pm
by woody90gtz
I fabricated my own flange out of the steel we had at work, and I got some of the good braided flex pipe. No problems with it yet and it has already been a month or so...
And this is from a video that I posted on bstuff, but forgot to post over here:
http://vids.myspace.com/index.c....3424503
And here's a vid of my 14.94...
http://vids.myspace.com/index.c....5742359