282 Input shaft seal.
Posted: Sun Mar 09, 2014 9:13 pm
Where can i find one? Am i going to have to buy a whole tranny?
Beretta.net
Official Chevrolet Beretta Owners Forums
https://www.beretta.net/forum/
282 Input shaft seal.
Page 1 of 1
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 12:19 am
Autozone had a rebuild kit with a new one. That was I only way I could find...
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 12:38 am
They don't have it anymore. Just a rebuilt that's $1400. Ill scrap the car before ill buy that...
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 1:33 am
Isn't that all contained within the input shaft sleeve and bearing?
PN 14092066
PN 14092066
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 3:25 am
What year beretta/trans?
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 3:29 am
TIMKEN Part # 222835 #8942495211, 94249521, 94379067 is what I'm pulling up.
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 3:39 am
Username/thread title. 
Those are for the Isuzu tranny. I have the Muncie/Getrag 282. RPO MG2
Those are for the Isuzu tranny. I have the Muncie/Getrag 282. RPO MG2
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 4:30 am
Should be able to come up with dimensions, and get the seal from a regular supply-house for under $10. I know this is only theoretical input, not specifics, but that is how I replaced the shift-shaft seal on my '90 282 several years ago, after GM stopped carrying them... I also had to match-up a seal on the six-speed F-40 trans in my GTU since I had to space-out the concentric slave on that trans (which is also one piece with the input-shaft seal 
) to close the gap to the clutch diaphragm...
) to close the gap to the clutch diaphragm...Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 4:56 am
Thanks, ill give that a shot... although I'm still open to suggestions.
Re: 282 Input shaft seal.
Posted: Mon Mar 10, 2014 7:26 am
282, just jb weld and rtv it.