Beretta.net

I'm going to have a crack at a parts car tomorrow, if the dew strips are good I want them. I'm assuming I just have to remove the interior door panel and the door handle cover. 2 bolts and some tabs I have to bend? any help would be sweeeeeeeeeeeeeeeeeeeeeeeeeeeeeeet!

Three screws that I remember(for the outside piece). The window must be down as you know. I had to use a micro ratchet for those magnetic screwdriver bits(with a #2 Phillips bit) because the 90 degree screwdriver wrenches are too long. You have to push the glass toward the inside just to get enough room.

http://www.filterbuy.com/toolsite/pics/mn08-0241.jpg
or
http://www.rodneydickman.com/dewstrip.gif

But if you dont care about the inside skin structure, why not just drill some holes to lessen the risk of damaging pull those parts?

I got them off with a micro ratchet screw driver worked perfect the strips are nice and soft no damage

Anyone know where to get new dew strips for our cars? The drivers side outer strip on mine is dry rotted and cracked..I'd love to get a new set of outer strips, just can't find em..

Junk yard or custom fit a similar profile strip like I did. There is no such thing as NEW Beretta dew strips unless someone has them stashed in a storage locker somewhere unused.

i would like to find that storage locker....

WHY???????????

I FOUND A SOLUTION THAT'S RENEWABLE! They are still making the weather strips that I'm using. Find OEM ones and you just have more 18yr old dew strips that will go bad and you will get sad about when they do.

What strips did you use?

http://www.beretta.net/forum/viewtopic. ... 45#p134145

http://www.beretta.net/forum/viewtopic. ... 73#p137073