Page 1 of 1
How to remove motor mount from bracket
Posted: Tue Mar 12, 2019 9:01 am
by Cam2363
I have a 96 z26 and I could not for the life of me figure out how to remove the rubber block bushing from the metal bracket. I snapped 2 screw drivers trying to get It out. I removed all the bolts and everything but got nothing. Anyone know how I'm supposed to get it out of the bracket? I think its welded in.
This is the mount on the left side next to the power steering pump
Re: How to remove motor mount from bracket
Posted: Wed Mar 13, 2019 9:43 pm
by whiteretta
Oh these can be a pain until you've done it once! Then it makes more sense. You gotta pry it out. Sorry bud!
Sent from my VS501 using Tapatalk
Re: RE: Re: How to remove motor mount from bracket
Posted: Wed Mar 13, 2019 11:06 pm
by Cam2363
whiteretta wrote:Oh these can be a pain until you've done it once! Then it makes more sense. You gotta pry it out. Sorry bud!
Sent from my VS501 using Tapatalk
Thanks, but actually, I found a great video saying I need to drill out the rivets on the bottom with a 9/16 drill bit. Did that and with a little prying. It came right out. So thanks for your help. But I figured it out, and a much easier method
Sent from my SM-G955U using Tapatalk
Re: How to remove motor mount from bracket
Posted: Thu Mar 14, 2019 6:43 pm
by whiteretta
How did I forget that... My bad!
Sent from my VS501 using Tapatalk
Re: How to remove motor mount from bracket
Posted: Thu Mar 14, 2019 10:12 pm
by Cam2363
whiteretta wrote:How did I forget that... My bad!
Sent from my VS501 using Tapatalk
Thats fine haha. Now just dealing with a rich run and a oil leak. The fun never ends
Re: How to remove motor mount from bracket
Posted: Wed Mar 20, 2019 8:09 pm
by whiteretta
Good luck! It's always something with an older car!
Sent from my VS501 using Tapatalk
Re: How to remove motor mount from bracket
Posted: Wed Mar 20, 2019 8:57 pm
by Cam2363
Always is. Thanks!
Sent from my SM-G955U using Tapatalk