Page 1 of 1
Inner tie rods replacement procedure.
Posted: Wed Nov 25, 2009 10:22 am
by Crash!
New here from Albuquerque! Hello!
A question... And yes, I searched... Are there any how-tos on inner tie rods on these forums?
Re: Inner tie rods replacement procedure.
Posted: Wed Nov 25, 2009 6:02 pm
by Money pit Beretta
Not that I know of. A Chilton's will give you an idea. I've only done the ends. What happened to your inner tie rods? Most of the time they hold up well.
Hi and welcome.
Re: Inner tie rods replacement procedure.
Posted: Thu Nov 26, 2009 10:38 am
by 3X00-Modified
Probably just inner tierod bushings that are bad... Get a set of those from Moog and you should be able to replace them easily. Remove the arm as a whole, burn out the bushing and then the replacements should be two piece.
Re: Inner tie rods replacement procedure.
Posted: Thu Nov 26, 2009 2:11 pm
by Barry
I just put MOOG ones in my car this weekend. They only cost me 16 dollars at autozone.
It is a pain to do with the engine still in the car, but its not too bad.
Re: Inner tie rods replacement procedure.
Posted: Fri Nov 27, 2009 11:01 am
by MY91GT(Z)
i love my delrin ones but those are limited and the only way to do them is like jon said by pulling the whole arm and burning them