Beretta.net

Posted: **Mon Apr 16, 2007 11:00 pm**

do i have to take the bell housing off to change the internal slave cylinder or is there anything special i have to do.i have a 1995, 2.2 liter engine,5 speed tranny.thanks

Posted: **Tue Apr 17, 2007 7:37 pm**

You have to remove the transmission to change the internal slave cylinder... it goes around the input shaft of the trans, which goes through your pressure plate/clutch disk and into your crank.

Posted: **Wed May 02, 2007 9:01 pm**

hi is there any way to check the slave cylinder for a leak without removing the transmission.thanks

Posted: **Thu May 03, 2007 12:56 pm**

There would be clutch fluid dripping from the transmission.