Beretta.net

Ok I found one off a vert Z24 and bought it. What I need to know is are the bolts needed? I couldn't save them.
It will be for sale if someone wants it. I can't use it on my 95.

Also I got the STB off of the car.

lower subframe brace? If so no the bolts are not needed.

Yeah, lower sub-frame brace??

Yes, right by the trans pan. It had four bolts on the Cav. So there are stock bolts there on early Beretta's and they are long enough to bolt this thing on?

Money pit Beretta wrote:Yes, right by the trans pan. It had four bolts on the Cav. So there are stock bolts there on early Beretta's and they are long enough to bolt this thing on?

Yes, those bolts are already there they are what bolts the subframe to the unbody rail. And the brace is less than 1/8 thick.

If you're sporting the 4t60e, it won't fit...

KFLO 93 GT wrote:If you're sporting the 4t60e, it won't fit...

Dis is true

I still have to make one to take its place.

Sounds good, you going to make more than one?

I'll put the bar and brace up for sale. I got the brace for someone that has an older car. It was just going to be crushed.

If its easy sure I'll make more than one.. but I haven't been able to look at it yet.

I just made a bay bar for the race car and that is VERY similar to what we need, just upside down.

Oh nice. I'm interested to see how yours turns out, Jon!

Me too! Looks nice!