Page 1 of 1
Turn Signal Arm Spring
Posted: Sat Nov 19, 2005 11:22 am
by Guest
I recently installed a turnsignal/multi-function switch in the steering column of my '90 GT and it seems to be loose. I can indicate fine but I cannot pull/push it forward or back for highbeam. Is there a spring that controls this that I missed during install?
Joe
Turn Signal Arm Spring
Posted: Sat Nov 19, 2005 11:37 am
by Guest
there's a rod that goes down to your switch on the column I had to adjust mine after I installed my switch too. ti's really easy follow the rod down to the switch loosen the two bolts move the switch toward the wheel tighten the bolts back finish.
Tom
Turn Signal Arm Spring
Posted: Sun Nov 20, 2005 9:50 pm
by Guest
thank you--I have needed to do this for my lumina for a while and didn't know how to do it.
Turn Signal Arm Spring
Posted: Mon Nov 21, 2005 7:37 am
by Guest
Glad to help out