Page 1 of 1
Need help fast guys!
Posted: Mon Jun 23, 2003 9:43 pm
by Guest
right now i am replacing my water pump and i am putting everything back togeter and cant figure out how to re-route the drive belt. i have a haynes manual and it is no help and i dont have a diagram on my belt gaurd. could someone post this please!!!
Need help fast guys!
Posted: Mon Jun 23, 2003 10:05 pm
by Guest
Here ya go
My bad, here is the one with A/C
Need help fast guys!
Posted: Tue Jun 24, 2003 7:24 am
by Guest
next time just remember to include what motor you have in your car so people can better help you, your lucky you taked to me online so i knew what to post.
Need help fast guys!
Posted: Tue Jun 24, 2003 5:08 pm
by Guest
thanks alot...i was WAY off until you posted that. after i talked to you i went out and got it in like 2 minutes.
Need help fast guys!
Posted: Tue Jun 24, 2003 5:13 pm
by MAJ28
It's all about the context clues Quote e/t-18.1 @ 73 mph
Need help fast guys!
Posted: Tue Jun 24, 2003 5:26 pm
by Guest
Quote (MAJ28 @ June 24 2003,15:13)It's all about the context clues  Quote e/t-18.1 @ 73 mph ÂÂÂ
c'mon man...its a 4cyl..what do ya expect from a non-quad4 and what do you mean about "context clues"?
Need help fast guys!
Posted: Tue Jun 24, 2003 6:17 pm
by MAJ28
Context, meaning the context(or content) or your sig... just by reading 18.1 it's easy to tell that it's the 4 version rather then the 3100.
-Jason
Need help fast guys!
Posted: Tue Jun 24, 2003 11:13 pm
by Guest
also doesn't it say "Belt routing diagram...2.2l" as the topic? last time i checked the 2.2L was a inline 4. lol jk. later