Page 1 of 1
tightening down the 3rd brake light
Posted: Thu Sep 22, 2011 5:13 pm
by themadness
that sum-bich is flopping around on the back deck like an epileptic at a strobe light convention. do i have to take the seats out to get to the back panel to tighten it down?
Re: tightening down the 3rd brake light
Posted: Thu Sep 22, 2011 6:18 pm
by DTMAce
There are 2 screws, one on each side near the base. That is all that should be holding it on. But I highly doubt you need to remove the seat at all. Other way to get to it, is from underneath the deck from the trunk.
Re: tightening down the 3rd brake light
Posted: Thu Sep 22, 2011 6:38 pm
by themadness
the 2 at the base are tight and i didnt see anything to tighten under the deck.
Re: tightening down the 3rd brake light
Posted: Fri Sep 23, 2011 6:40 am
by scd88ga
themadness wrote:the 2 at the base are tight and i didnt see anything to tighten under the deck.
That's because it screws down on top of the the rear deck, it's a metal bracket. Remove the two side screws from the light housing and take the assemble out.