Page 1 of 1
NVG T550 disassembly.
Posted: Sun Feb 05, 2012 5:09 pm
by Barry
Heres where I am at. How do I remove the shafts from the trans? Theres no bolts there like there is on the getrags...
Re: NVG T550 disassembly.
Posted: Sun Feb 05, 2012 6:32 pm
by 3400beretta
Kinda hard to see from the pic, but I think I know what you are talking about.
There hex head bolts there, they are reverse threaded though.
I had to buy a special hex drive socket IIRC it is 12mm. Used an impact gun to get em out.
Re: NVG T550 disassembly.
Posted: Sun Feb 05, 2012 11:12 pm
by Barry
Thanks Rodney, I'll look into it further. It looks like roller bearings in there, but maybe there hex. I hope so
Re: NVG T550 disassembly.
Posted: Mon Feb 06, 2012 4:33 pm
by 3400beretta
Yep, I believe they are 12 point hex so yeah at a quick glance would look like needle bearings.
Re: NVG T550 disassembly.
Posted: Mon Feb 06, 2012 6:08 pm
by Barry
3400beretta wrote:Yep, I believe they are 12 point hex so yeah at a quick glance would look like needle bearings.
I am praying that your right. Thanks!