Beretta.net

My dad drove the 93 quad, putting into reverse he said it poped and now no bushing on the cable end and retainer to hold it on the shifter. where can I find these bushings, I searched but can't find them. Thanks in advance

I think you can use Booger Bushings on that. I had a link at one time, but it's gone now. I listed it some where in a post. Hope they still make them for GM cars!

Money pit Beretta wrote:I think you can use Booger Bushings on that. I had a link at one time, but it's gone now. I listed it some where in a post. Hope they still make them for GM cars!

That's all I could find, don't know if they are right but I ordered them and figure I could trim to fit. Thanks

I used a faucet bushing and some washers from menards... Works great! The bushing is the exact size if you find the right one and only cost 69 cents! .. if its the same bushing for selector cable that your talking about

88gtz wrote:

Money pit Beretta wrote:I think you can use Booger Bushings on that. I had a link at one time, but it's gone now. I listed it some where in a post. Hope they still make them for GM cars!

That's all I could find, don't know if they are right but I ordered them and figure I could trim to fit. Thanks

Last I heard they were direct replacements. Your welcome.

they are direct replacements, i have an extra set if interested pm me