Page 1 of 1
So im going to the salvage yard
Posted: Tue Nov 15, 2005 1:45 am
by Guest
Im taking a trip this friday for some body pices few switches, and maybe a few other pices.
First off im runing a 92' 3.1 auto retta.
I would like to get better heads, headers, cam ( altho i may order this from CC) I know there are a few eng. tha i can swap parts. So any ideas on few part i should look for?
I will be sending any parts i get to be cleaned/rebuilt.
So im going to the salvage yard
Posted: Tue Nov 15, 2005 1:56 am
by TurboGTU
Good condition dash, door panals, and rear panals?
Sway bars off GTU or Z26.
96+ heads and up top end off 3100/3400...or compleate engine..$$$.
So im going to the salvage yard
Posted: Tue Nov 15, 2005 2:10 am
by Guest
I have maybe $400 to blow. And i dont wanna do a total swap. I think my dad has a eng. from a 90+ bonnieville SSE (spelling) just lying aroundcould i inter change parts from that? ill get the right year tomorrow when i call him.
So im going to the salvage yard
Posted: Tue Nov 15, 2005 3:57 am
by TurboGTU
IF its the SSEi superchaged 3.8..with all the the bells and whitles like alternator, power steering pump, SUPERCHARGER and what nots...then I'd consider a engine swap...and spend the rest on engine mounts.
But if you want cheap/cheap. Grab the 1.6 ratio rocker arms from a 94-95 chevy beretta 3100. Ours come stock with 1.5 ratio. Making a ram air setup would be grovvvy.
You might want to drop the tranny if your going to do any engine work and install a shift kit.
So im going to the salvage yard
Posted: Wed Nov 16, 2005 2:05 am
by Guest
**** it im doing a swap.
3.1 L MPFI goodbye
3400 Hello
Whats the best year and car to look for? by that mean the one that has most in common.
I have any auto anyone doen this yet, how easy is it?
I have an old 96 (i think) bonniville SSE with no motor, think the 3.1 will fit init? If so i can sell it and buy racing parts
So im going to the salvage yard
Posted: Wed Nov 16, 2005 3:33 pm
by brilamb2
01 impala
So im going to the salvage yard
Posted: Wed Nov 16, 2005 7:08 pm
by wht89gt
hey all i am getting ready to do an engine rebuild on a 2.8 liter v6 my question is should i rebuild the 2.8 or go with something bigger like a 3.1 or what will fit in my beretta like i siad right now i have the 2.8 that has a bottom end knock its not bad but if you listen close you can hear it......... thanks
So im going to the salvage yard
Posted: Wed Nov 16, 2005 7:25 pm
by 1988GTU
You could do the 3.1MPFI direct bolt in swap, but you could also go the extra short mile & do a minor mod 3400SFI swap and gain the modern look, tech, reliablitiy, PERFORMANCE etc etc.....
Do a search on "3400 SWAP" on here.
So im going to the salvage yard
Posted: Wed Nov 16, 2005 8:17 pm
by wht89gt
ok thanks i will do that and thanks for the info
So im going to the salvage yard
Posted: Wed Nov 16, 2005 9:07 pm
by TexanBerettaGT
3400swap.com