Selling my Z26-floor board didnt pass state inspection

List a Beretta Item for sale
User avatar
GT_Indy
Registered User
Posts: 615
Joined: Thu Apr 21, 2016 2:23 pm

Re: Selling my Z26-floor board didnt pass state inspection

Postby GT_Indy » Tue Aug 29, 2017 10:48 pm

Julie96Z26 wrote:8/28/2017 $1,000 cash/trade takes it ,that should take care of needed repairs .I prefer it repaired - NOT parted out > The underside is bad/rusty <
.it had the typical water leak that thrashed the floor board on the passenger side
.pinch lip so-so .It will go into the barn before the demo-derby , julie96Z26.
1996 the last year of the Beretta?


Depends on how far the rust has gone, if the underside is that bad there is a good chance it will have a hard time selling unless someone really wants the car to part. Photos help a lot with rust.
If I was to consider it, I would for sure part it for myself because the parts would be worth more to me than the car.
Personally I have only seen 1 other member do a full restoration so far on these cars.



1987GT
Registered User
Posts: 5
Joined: Tue Sep 26, 2017 6:55 pm

Re: Selling my Z26-floor board didnt pass state inspection

Postby 1987GT » Tue Sep 26, 2017 7:09 pm

I'll give you 500.00 for it and no it will not be parted out but restored. I am in Ohio, about 15 miles west of Wheeling. Please PM me.



1987GT
Registered User
Posts: 5
Joined: Tue Sep 26, 2017 6:55 pm

Re: Selling my Z26-floor board didnt pass state inspection

Postby 1987GT » Wed Sep 27, 2017 8:44 am

Still available?



User avatar
daguse5853z
Registered User
Posts: 268
Joined: Sun Feb 12, 2006 7:35 pm
Location: Central, PA

Re: Selling my Z26-floor board didnt pass state inspection

Postby daguse5853z » Fri Sep 29, 2017 5:10 am

Sounds like the unibody is toast.



User avatar
GT_Indy
Registered User
Posts: 615
Joined: Thu Apr 21, 2016 2:23 pm

Re: Selling my Z26-floor board didnt pass state inspection

Postby GT_Indy » Fri Sep 29, 2017 11:00 pm

daguse5853z wrote:Sounds like the unibody is toast.


Anything can be fixed, depends on motivation, resources, funding, etc.
Photos would really help his car sell. Even photos of the rusty parts.



User avatar
Julie96Z26
Registered User
Posts: 7
Joined: Wed Jun 14, 2017 8:27 am

Re: Selling my Z26-floor board didnt pass state inspection

Postby Julie96Z26 » Sun Dec 12, 2021 3:53 pm




User avatar
GT_Indy
Registered User
Posts: 615
Joined: Thu Apr 21, 2016 2:23 pm

Re: Selling my Z26-floor board didnt pass state inspection

Postby GT_Indy » Mon Dec 13, 2021 6:40 pm

That isn’t terrible. Looks like the bottom parts rotted on the side rails.

The car may have some life left for someone in another state.

I had an 88 in Ohio years ago that was rotted worse than that to where it was sagging in the middle enough to notice the doors were 0.5-1.0 cm off. Haha




Return to “For Sale”

Who is online

Users browsing this forum: No registered users and 6 guests