Wanted: Lower subframe brace

[3X00-Modified]

It's not that clean lol, and you mean that metal clip? I already have that I just need new loom to go on the wires, I didn't get that done yet.

[Cliff8928]

Ok 3X00 one more thing. A plug wire holder that goes by the PS pump. Not a stock item on a Beretta, but it sure cleans up the engine bay.

Wow, never mind on cleaning up the engine bay. That thing looks new.

That round clip that holds the wires did come from the factory. The '88s had an actual plastic fitted guide that the wires fit inside that ran the length of the plenum and was attached by two bolts. That was the best looking setup on the 2.8/3.1 but it required 7mm wires unless modified.

[Money pit Beretta]

I'll dig it up and get a photo if needed. I'd say it is what the 88's had, does run the length of the plenum and is made of ABS. I think it was taken off a Buick 2.8/3.1L.
The problem is I didn't get the bolts.

I will be sending you a Dana gasket #35571 for the coolant tube that is in the top of the water pump. Bought three way back when because I was told they were the best and no longer made. Yes, they were the stores last three(lol).