GTU in the junkyard

DOHC_tuner · Post by **DOHC_tuner** » Thu Jun 02, 2011 6:41 pm

speedy wrote:hmm, did you see theres a gtz there? how were the visors?? and if you dont know, gtz visors are very specific, they have a plastic piece that slides out almost like an extension. the rest of the fleet of retta's didnt get them, sucks for them, ha. grey interior im assuming?? also, theres some other things im sure i'll need, just give me time to think...

There was a GTZ there. I did not know that about the visors....Let me know what you need...

felixGTU · Post by **felixGTU** » Thu Jun 02, 2011 8:12 pm

Does this gtu have the emblem that goes on the dash? the one that says " Beretta GTU" if it does im intrested in that.

DOHC_tuner · Post by **DOHC_tuner** » Fri Jun 03, 2011 2:48 pm

I will check....I like your sig looks just like the one in the jy

Post by **3X00-Modified** » Fri Jun 03, 2011 3:20 pm

I doubt the one in the JY has a hood like the one in his sig...

Post by **Cliff8928** » Sat Jun 04, 2011 12:43 am

3X00-Modified wrote:I doubt the one in the JY has a hood like the one in his sig...

Or the wheels, or the spoiler.... etc...

Post by **Styluss** » Sun Jun 05, 2011 2:25 pm

I never noticed anything different about the spoiler in that stock photo...

DOHC_tuner · Post by **DOHC_tuner** » Sun Jun 05, 2011 6:33 pm

Im confused....looks the same to me.

Wheels, spoiler, and hood.

Post by **Cliff8928** » Sun Jun 05, 2011 11:09 pm

Styluss wrote:I never noticed anything different about the spoiler in that stock photo...

Just look at a pic of it from the side...

Post by **Styluss** » Mon Jun 06, 2011 3:22 pm

DOHC_tuner wrote:Im confused....looks the same to me.

Wheels, spoiler, and hood.

Wheels: Have a concave center.
Hood: Has a 1 inch cowl.
Spoiler: Explained above.

That spoiler is SICK! Now, I have to find one... OH KYLE!!!

felixGTU · Post by **felixGTU** » Mon Jun 06, 2011 3:55 pm

Now why didn't the Beretta have this? The rims look better than my stock GTU. I just could not figure out why. But now that you mention it, I do see it.

Post by **Styluss** » Mon Jun 06, 2011 6:24 pm

I always get a laugh looking at the second pic. This was used as a dealer promo photo and look at the huge misalignment between the door and the quarter panel!

Chad91GTZ · Post by **Chad91GTZ** » Mon Jun 06, 2011 11:24 pm

And the empty stud for the antenna just hanging out on the fender. I drive mine around like that too. haha

Post by **Cliff8928** » Tue Jun 07, 2011 1:10 am

Wow, i just noticed that misaligned belt moulding.

As for the wheels, they would've cost more to make. The spoiler probably would've blocked the CHMSL, and the hood was probably scrapped for cost saving as well. If you blow the pic up, the cowl looks like it is an add-on.

2.2H8TA · Post by **2.2H8TA** » Tue Jun 07, 2011 2:06 am

If you want a spoiler like that... Take a GTU spoiler, put it on, and find a Camaro SS, newer body, not sure of the year, but they have 3 peice spoilers on em'. I bet the peices that go on the rear quarters fit. I have parked my base next to one, and just looked, didn't measure, but it really looks like it'd work. A bit of modifyin' may be needed, kinda like the Z34 spoilers, but I think it's worth it!

Post by **Styluss** » Tue Jun 07, 2011 2:43 pm

Cliff8928 wrote:The spoiler probably would've blocked the CHMSL

Umm... The spoiler has its own CHMSL

Beretta.net

GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Re: GTU in the junkyard

Connect with your social network account