Page 1 of 1
1990 3.1 missing flywheel cover???
Posted: Thu May 26, 2011 9:49 pm
by indyyellow
I noticed that the fly wheel is exposed. Shoud it be? If not what motors if any other then the 3.1 have the same cover?
Re: 1990 3.1 missing flywheel cover???
Posted: Thu May 26, 2011 9:53 pm
by woody90gtz
Mine has a cover that was bent & rubbing on the fw. I'd like to know where to find a good one...
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 10:50 am
by indyyellow
Anyone? is there another GM cars flywheel cover that will fit on my 1990 3.1 motor?
Does it hurt any toleave it uncovered?
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 11:09 am
by scannerman
indyyellow wrote:Anyone? is there another GM cars flywheel cover that will fit on my 1990 3.1 motor?
Does it hurt any toleave it uncovered?
i be that part is the same on all 60* V6 cars. don't know if it varies between autos and manuals.
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 11:40 am
by 3X00-Modified
As woody said, I think the manuals are Metal covers... Mine on the 3x00 are two plastic parts, one for the bottom and one for around the starter.
As far as if it will hurt anything being exposed... well there is the chance that you can get sand and rocks up in there if they bounce just right. I know the factory stuff doesnt seal it 100% but it does keep out large debris that can mess with the clutch.
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 12:32 pm
by ronaconda
1990 will be a one piece plastic part for autos and a metal piece for manual trannys. Any other late 80's/early 90's GM car with the same engine/trans combo as yours should have the part you need.
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 12:54 pm
by indyyellow
thanks guys.
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 2:35 pm
by woody90gtz
I read flywheel and assumed manual. I wonder if even a quad cover would fit my getrag. That part of the bellhousing shouldn't be different.
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 3:46 pm
by ronaconda
woody90gtz wrote:I read flywheel and assumed manual. I wonder if even a quad cover would fit my getrag. That part of the bellhousing shouldn't be different.
Good question. The starter, being much lower on the 3.1, would be the only reason i could see them being different.
Re: 1990 3.1 missing flywheel cover???
Posted: Fri May 27, 2011 4:03 pm
by SuzukiGhostRider
I don't know about '90, don't remember, but all my Quads have PLASTIC flywheel shields.
Re: 1990 3.1 missing flywheel cover???
Posted: Sat May 28, 2011 12:40 am
by Cliff8928
woody90gtz wrote:I read flywheel and assumed manual. I wonder if even a quad cover would fit my getrag. That part of the bellhousing shouldn't be different.
Well, my flywheel cover has the starter going through it.