Digital dash connection question
Posted: Tue Jul 05, 2011 11:49 am
1990 Beretta w/digital dash. Is there a certain way when taken out that it needs to be put back in. Any sequence, say take off battery cable, then install then put batt cable back on. When I was messing with it before I sent mine out ofr fix I could take it in and out with the car running, did not matter. Any harness things to look for, fuse issues which I checked, all were good.
Place that rebuilt it says to check for bent pins on unit, none, check harness for loose wires going into it which I did but will chech again before I send it back out.
Am I missing anything?
The fools don't want to pay for shipping even though it is under warranty and they messed it up!
Place that rebuilt it says to check for bent pins on unit, none, check harness for loose wires going into it which I did but will chech again before I send it back out.
Am I missing anything?
The fools don't want to pay for shipping even though it is under warranty and they messed it up!