Digital dash connection question

indyyellow · Post by **indyyellow** » Tue Jul 05, 2011 11:49 am

1990 Beretta w/digital dash. Is there a certain way when taken out that it needs to be put back in. Any sequence, say take off battery cable, then install then put batt cable back on. When I was messing with it before I sent mine out ofr fix I could take it in and out with the car running, did not matter. Any harness things to look for, fuse issues which I checked, all were good.
Place that rebuilt it says to check for bent pins on unit, none, check harness for loose wires going into it which I did but will chech again before I send it back out.
Am I missing anything?
The fools don't want to pay for shipping even though it is under warranty and they messed it up!

Post by **Cliff8928** » Wed Jul 06, 2011 12:56 am

What's it doing?

indyyellow · Post by **indyyellow** » Wed Jul 06, 2011 2:31 pm

sent it to them 95% working (odom mostly out and the mode section under it not working) unit, got back a 5% working unit. It is back out in the mail to them to look at.

Beretta.net