Beretta Z28

[jjanke]

Hahaha...there's still an un real amount of work to do...but think it possible to be done next summer at least for driving and shake down purposes. ....the car is staying white and the z28 decals are black.

[Ugly_Monkey]

You sir, give me hope... and a little bit of sanity back. Cheers!

[jjanke]

Got a spare set of 16s that were in near perfect condition for free. And got a new set of 245s to burn off

[jjanke]

Cut out the x body braces and stitch welded the body flanges to the frame rails

[jjanke]

Put together a sheet metal brake with some 3.00 $ hinges and some scrap 1x1 square tube. Made some test bends and think its gonna be great for making some quick panels for the build and what ever else...radiator shroud and wiper cowl coming soon

[jjanke]

picked up some goodies!!!! Modified front spindles, power steering rack with extended tie rods, tubular lower control arms, hydro handbrake, and dual rear caliper set up..... this is the stuff thats gonna make the bere

tta or camaro a competitive chassis with lots of steering angle !!!!!!!!!!!!!

[jjanke]

Finished the radiator shroud/bracket

[jjanke]

[1988GTU]

Fast progress and you sure don't take breaks! Can't wait to see the brakes all complete with the suspension.

[jjanke]

Thanks 88gtu. Gotta keep pushing. .....winters coming soon .....gotta get some heat in the garage if im gonna work all winter in order to be on the road in the summer.... ......as for the brakes and steering/suspension mods might wait till the car is on the road before upgrading ........focus on getting it running and driving .....then upgrades

[bonecrrusher]

Nice sheet brake!

Your looking for heat - I'm looking for AC in my shop!

[woody90gtz]

It looks like the footwell area is pushed back quite a bit. Using the deep Camaro dash I take it?

[jjanke]

..the camaro dash is just to wide.....im definitely gonna use the stock camaro gauge cluster.....and see if the beretta dash or chopped up camaro dash will be less work ....... or some kind of bent metal im thinkin might be the easiest

[jjanke]

I definitely need to re focus on the metal work and filling all the small gaps and patches in the fire wall and inner fenders and rear/trunk area......

[jjanke]

Got my rear differential back. Swapped in a 373 gear. And the open carrier from the 6cyl which now is welded. Also had to replace one of the axles due to the Bearing collar wearing into the axle shaft .also all new bearings seals and gaskets. Rear diff is back in full of fluid and ready to rock !!!!