96 beretta stuck in 3rd or 4th gear?
-
- Registered User
- Posts: 389
- Joined: Sun Apr 15, 2012 11:40 am
96 beretta stuck in 3rd or 4th gear?
1996 chevy beretta. 3100 v6
4 speed automatic.
The car is stuck in 3rd gear when in drive, wont use any other gears at all? revers and park work fine.
4 speed automatic.
The car is stuck in 3rd gear when in drive, wont use any other gears at all? revers and park work fine.
Last edited by Beretta1234567 on Thu Apr 21, 2016 2:56 pm, edited 1 time in total.
-
- Registered User
- Posts: 70
- Joined: Thu Jan 15, 2015 6:47 pm
Re: 96 beretta stuck in 3rd or 4th gear?
Check fluid level first. Not knowing the power flow of the 4T60E I would guess either the solenoids or a seal are blown. Does it work after warming up?
-
- Registered User
- Posts: 389
- Joined: Sun Apr 15, 2012 11:40 am
Re: 96 beretta stuck in 3rd or 4th gear?
Nope. I let it get up to temp and it is still stuck in what seems to be 3rd gear.
Last edited by Beretta1234567 on Thu Apr 21, 2016 2:57 pm, edited 1 time in total.
-
- Registered User
- Posts: 70
- Joined: Thu Jan 15, 2015 6:47 pm
Re: 96 beretta stuck in 3rd or 4th gear?
Hmmm than I'd say its a lip seal on the clutch pack for 1-2 or an accumulator seal is out.
- 3X00-Modified
- Administrator
- Posts: 10912
- Joined: Thu Jul 05, 2007 9:18 am
- Location: Brooklyn CT
Re: 96 beretta stuck in 3rd or 4th gear?
Probably more like the valve body is stuck. Without the input and 2nd clutch packs 3rd wont work. Its a combination of all 3 engaged at once to get 3rd gear, and the 3rd pack releases to go into 4th. I doubt this is anything that can be fixed without a teardown. Are you sure the car isn't in a limp mode? No SES light?
Re: 96 beretta stuck in 3rd or 4th gear?
I did some nosing around and found this:
http://www.fullsizechevy.com/forum/gene ... times.html
I hope this helps.
http://www.fullsizechevy.com/forum/gene ... times.html
I hope this helps.
-
- Registered User
- Posts: 389
- Joined: Sun Apr 15, 2012 11:40 am
Re: 96 beretta stuck in 3rd or 4th gear?
I pulled the front connector off the transmission, cleaned it and its working again.
I want to change my transmission fluid just it case, its been a while and looks dirty.
I want to change my transmission fluid just it case, its been a while and looks dirty.
-
- Registered User
- Posts: 70
- Joined: Thu Jan 15, 2015 6:47 pm
Re: 96 beretta stuck in 3rd or 4th gear?
Ahhhh good, probably just material gumming up the solenoid. I figured it was something a little less simple. Usually when lip seals fade they'll work poorly cold but get marginally better warm. Good thing it was an easy fix!GHOSTOWLGRID wrote:I pulled the front connector off the transmission, cleaned it and its working again.
I want to change my transmission fluid just it case, its been a while and looks dirty.
Re: 96 beretta stuck in 3rd or 4th gear?
The 4t60 will default to 3rd if the pcm detects a electrical fault or there is a loss of power to the solenoids mounted on the valve body.
Sent from my SPH-D710 using Tapatalk
Sent from my SPH-D710 using Tapatalk
1988 Beretta GT 5 speed - 1st car... Gone to the crusher.
1989 Beretta GT Z-51
1994 Beretta Z26 getting FE7+Z51 goodies
1987 Pontiac Bonneville LG3+4T65-E
1987 Chevrolet Celebrity Wagon L36+4T65-E
1998 Chevrolet C1500 5.7L L31+ built 4L60-E
1989 Beretta GT Z-51
1994 Beretta Z26 getting FE7+Z51 goodies
1987 Pontiac Bonneville LG3+4T65-E
1987 Chevrolet Celebrity Wagon L36+4T65-E
1998 Chevrolet C1500 5.7L L31+ built 4L60-E
Re: 96 beretta stuck in 3rd or 4th gear?
So I guess you thought to check the electrical connection on your own.
Just wondering if my link was helpful or not?
Just wondering if my link was helpful or not?