z26 problems
- SuzukiGhostRider
- Registered User
- Posts: 2464
- Joined: Tue Feb 12, 2008 4:07 am
- Location: Milan NM
- Contact:
Re: z26 problems
You pretty much just gave a TEXT BOOK description of a bad or failing fuel pump. Something which I noticed only ONE person in this entire thread mentioned.zszach wrote: ... it is ideling really rough and spits and sputters all the time when you get on it or are just regular driving it.....
That pressure test should have verified that to you , judging by the results of it.
I would change the fuel pump or just get the complete assembly which makes life easier. Make sure you also put the NEW wiring harness on and a new fuel filter (yes I know you just replaced yours, but you need to put a brand new one on when doing a new fuel pump) as well as a new "sock" filter (if it doesn't come with one already) on the assembly.
I recommend the assembly because in a car that old, it's always a good idea, as the sending units are usually off anyhow and just due to the sheer age of the unit.
Re: z26 problems
ok got a update i put a fuel pump in it, it helped it alot now it doesnt sputter sittin still, but it will sputter takin off and at low rpms when your drivin it. does anybody have a idea of what this could be im comin down to thinkin it might be the injectors again so im gonna check them over when i get the intake off
if its not that then im stuck so somebody PLZ help
if its not that then im stuck so somebody PLZ help

- Money pit Beretta
- Registered User
- Posts: 6411
- Joined: Thu Jul 26, 2007 11:36 am
- Location: Kansas
Re: z26 problems
filter has been changed, also ive come down to think its the injectors now, i pulled the whole rail out injectors and all and flipped the switch on even tho the pump was on and fuel hit the lines nothin came out of the injectors, changed the fuel pressure regulator and still nothin, im thinking that the injectors are clogged up which could be why it started with a small sputter and slowly got worse. the injectors will spray but you have the trn the motor over 2 or 3 times before you will get a little spit and then nothing again. does anyone no if there is a injector relay or somethin that would cause them to not work besides the fuse in the dash or am i looking at swapping the injectors out

-
- Administrator
- Posts: 1775
- Joined: Wed Mar 03, 2004 10:03 pm
- Location: Long Grove, IL
- Contact:
Re: z26 problems
Nothing is going to come out of the injectors unless the engine is actually turning.
Cliff Scott


Re: z26 problems
you sure i has a 89 that you could flip the switch on and it would spray out everywhere, also even then the fuel doesnt i can turn the motor over and it usually takes 3 or 4 turns before it will actually shoot fuel out

-
- Registered User
- Posts: 1035
- Joined: Thu Feb 20, 2003 11:21 pm
- Location: South Central MN
Re: z26 problems
Have you checked the ohms on the injectors?
94 Beretta Z26 57,4xx miles
3100, auto, crank windows, power locks/trunk, A/C,
To many mods to list
-intercooler
Among beretta boards
1st Turbo 4t60-e
1st Turbo 3100
1st Turbo Z26
1st 94+ Turbo
3100, auto, crank windows, power locks/trunk, A/C,
To many mods to list
-intercooler

Among beretta boards
1st Turbo 4t60-e
1st Turbo 3100
1st Turbo Z26
1st 94+ Turbo
- 3400beretta
- Registered User
- Posts: 281
- Joined: Fri Mar 10, 2006 2:21 am
Re: z26 problems
There are only two things that can cause the fuel pressure to be too high. One is a faulty regulator, the other is a blocked/pinched return line.zszach wrote:ok i got a fuel pump pressure tester and it showed up that it was way over presured the thing it led down to is either a pump or a fuel pressure regulator i have changed the regultor before with a good used one but it hasnt seemed to help, does anyone no anything i can try before i go and tear out the pump
Why would you change the pump if the pressure is reading too high? That doesn't make any sense whatsoever.
Re: z26 problems
put injectors on it and that helped it alot, it actually runs great besides the fact that when you stomp on the gas to hard it will start to sputter out.. not sure what this could be cuasing it... anybody got any solutions.

- 3X00-Modified
- Administrator
- Posts: 10915
- Joined: Thu Jul 05, 2007 9:18 am
- Location: Brooklyn CT
Re: z26 problems
A running scan of the ECM would help diagnose the problem much easier than just throwing parts at it. You could be here all day going through fuel parts and ignition parts.
Re: z26 problems
your fuel pump is fucked. i had this SAME problem on my car. buy a NEW one and it will run great.