trim piece wont budge

If there isn't a place for your question then put it here.
Post Reply
themadness
Registered User
Posts: 885
Joined: Sat Jun 18, 2011 9:48 am

trim piece wont budge

Post by themadness »

the bottom driver side trim piece wont budge! it was pulled back when i bought it and i cant get it to snap back up. suggestion?
Attachments
downsize.jpg
User avatar
DTMAce
Registered User
Posts: 3510
Joined: Thu Sep 25, 2008 7:03 pm
Location: Michigan EUP
Contact:

Re: trim piece wont budge

Post by DTMAce »

Use a hard rubber or plastic mallet.

Simple repair procedure to follow:

If it won't move, force it. If it breaks, it needed replacing anyway.
94' Z26 Project - 95' Base Project - Custom LED Light Conversions!
Chosen Proposal Submission & Committee Member for Beretta Fest 2012 in Traverse City Michigan

Image
Image
User avatar
Wanako
Registered User
Posts: 1098
Joined: Fri Apr 04, 2008 2:29 am
Location: Torrance, CA

Re: trim piece wont budge

Post by Wanako »

DTMAce wrote:Use a hard rubber or plastic mallet.

Simple repair procedure to follow:

If it won't move, force it. If it breaks, it needed replacing anyway.
:ROFL:

:good:
User avatar
DTMAce
Registered User
Posts: 3510
Joined: Thu Sep 25, 2008 7:03 pm
Location: Michigan EUP
Contact:

Re: trim piece wont budge

Post by DTMAce »

That goes along with:

If it moves and isn't suppose to, use duct tape.

If it doesn't move and its suppose to, use WD-40.
94' Z26 Project - 95' Base Project - Custom LED Light Conversions!
Chosen Proposal Submission & Committee Member for Beretta Fest 2012 in Traverse City Michigan

Image
Image
Post Reply