1996 Z26, born in a barn!

Tell us about your Beretta and Post an Image
User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

1996 Z26, born in a barn!

Post by Chad91GTZ »

So a while back I came across this this Z26.

It needs some serious help. I finally have most of the pieces of what it needs to be put back together. The pictures should speak for themselves.


Doesn't look to bad here. But it gets worse.
Image
Image


Somethings wrong here. I guess they hit something lol. The control arm is wasted, and the axle has wholes in both boots. Knuckle is bent, strut is bent, sway bar is bent, lol. OUCH. Car wouldnt be able to be move without the doughnut on it.
Image


The entire kit is wasted. Some minor front end damage, nothing serious. Need a new hood latch assembly, its bent.
Image
Image
Image
Image
Image

The "new" fender was trash, but it can probably be fixed. The piece of junk welds on the hood hinge bolt let loose. Hard to tell if it happend before or after it got smashed.
Image

There were a few critters living in the unit. lol
Image
Image


Pretty much the only rust on the unit. Unfortunately, it goes all the way through, and the bottom of the rocker is mostly gone. This is going to be my new winter car, but I will probably cut the cancer out and replace. But that will come much later.
Image


Extra parts? lol Its missing some interior stuff, (passenger seat comes to mind) and Im not a fan of the painted crap inside the cockpit.
Image
Image


So far I have the front of the car torn off. I'm kinda stuck now, as it didnt come with a wheel lock key (that ive found so far lol). Also, the car doesn't run atm. I have NO idea how long its been since it was started, but the oil looked good, and the gas tasted ok. (yes I said tasted). I dont hear the pump turn on, so I either need a new pump (they are 300 dollars, I was shocked) or a relay. Haven't tested it yet.

I got a hood, fenders, full Z kit, trunk lid, spoiler, air dam, all the fog lights, fog light harness, headlights, turn signals from a near mint 95 Z at a yard near me for a cool 160 dollars. They have some rock chips and cracked paint here and there, but the rest of the car is no cream puff. A little TLC here and there and Ill have a good runner.

Wish me luck! Hoping to be done before the 20th, I wanna take it to the WI GM Tuners gathering to make my friend Morgan jealous. He wants a white Beretta, and I got this one for free, lol.


Realized I forgot to include WHY it was born in a barn. I got the car for free! I was driving by a house and I saw a beretta sitting in an out building. Went to check it out to see if it was for sale and it was. Apparently it was his sons car, who I guess was in the service and didn't make it home. He was planning on junking it or turning it into a field car, but after talking to him, his son loved the car, and wanted to see it put back together. I towed it home later that day.
Last edited by Chad91GTZ on Tue Aug 09, 2011 12:10 am, edited 1 time in total.


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

Re: 1996 Z26, born in a barn!

Post by Chad91GTZ »

reserved for future updates >:D


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
User avatar
DTMAce
Registered User
Posts: 3510
Joined: Thu Sep 25, 2008 7:03 pm
Location: Michigan EUP
Contact:

Re: 1996 Z26, born in a barn!

Post by DTMAce »

I see the red base behind it. Still need anything else for that one? lol


94' Z26 Project - 95' Base Project - Custom LED Light Conversions!
Chosen Proposal Submission & Committee Member for Beretta Fest 2012 in Traverse City Michigan

Image
Image
User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

Re: 1996 Z26, born in a barn!

Post by Chad91GTZ »

Nope, but I will have some base parts for sale if I go ahead with the plans for it, if I dont sell it.


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
User avatar
Money pit Beretta
Registered User
Posts: 6411
Joined: Thu Jul 26, 2007 11:36 am
Location: Kansas

Re: 1996 Z26, born in a barn!

Post by Money pit Beretta »

Lots of work there. Some have it and some don't. I sure don't. Thought I did on a 67 Camaro, but gave up after two years. Keep updating. Every Beretta saved is a win for all of us. It would be great to take it back and show that guy what has been done for it.


keep'em flying!
User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

Re: 1996 Z26, born in a barn!

Post by Chad91GTZ »

Front end is torn down. My 23 dollar each strut didn't come with new boots etc, so ill pick those up tomorrow.

Also, I'm pretty sure the sway bar is bent. I might just take it out rather than try to find a new one.

Figured out why it didn't run minutes after starting my serious trouble shooting this evening. Fuel pump/injector fuse was blow. Easy fix. Lol. Car runs like a champ, sounds bad ass with the hole in the exhaust before the cat haha

Image


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
User avatar
99GaGT3X00
Registered User
Posts: 805
Joined: Tue Jan 11, 2005 1:56 pm
Location: North Brookfield,MA
Contact:

Re: 1996 Z26, born in a barn!

Post by 99GaGT3X00 »

is the drivers side headlight half filled with water or is it just an optical illusion or cracked.


Image
3400/3500 Hybrid
227/233@.050 .515.515 lift 112LSA
15.232@88.85mph on stock 3400

99 Grand Am GT------03 Subaru Outback H6
User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

Re: 1996 Z26, born in a barn!

Post by Chad91GTZ »

Cracked in half, all the mounts were busted off. It fell apart when I took it off the car lol. I'm not sure what the guy hit, but he hit it good. I'm guessing it went ditch diving from the grass still under the car.


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
User avatar
Barry
Global Moderator
Posts: 1871
Joined: Fri Feb 29, 2008 8:11 pm
Location: Hatfield Pa

Re: 1996 Z26, born in a barn!

Post by Barry »

That is one beat z26, but the price is right!


User avatar
SuzukiGhostRider
Registered User
Posts: 2464
Joined: Tue Feb 12, 2008 4:07 am
Location: Milan NM
Contact:

Re: 1996 Z26, born in a barn!

Post by SuzukiGhostRider »

Yeah, that thing looks pretty sorry. GL with it.


Image
User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

Re: 1996 Z26, born in a barn!

Post by Chad91GTZ »

You won't even recognize it after this weekend.


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
User avatar
berettaboi
Registered User
Posts: 973
Joined: Sun Mar 23, 2008 10:58 pm
Location: canananada

Re: 1996 Z26, born in a barn!

Post by berettaboi »

good stuff, congrats on the freebeee. yeah definitely take it back and show the previous owners father when it's all fixed up.


4th one's a charm, 5th one is, beginnning to sound like this is an addiction...
95 black z26, '96 White z26 awaiting new life, and 2.5 mazda trucks
Image
User avatar
snowblindburd
Administrator
Posts: 1152
Joined: Sun Sep 25, 2005 8:48 pm
Location: Wisconsin

Re: 1996 Z26, born in a barn!

Post by snowblindburd »

Ugh that taunting red base.

Good luck with the Z, Chad! It will make Mr. Morgan jealous for sure.


User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

Re: 1996 Z26, born in a barn!

Post by Chad91GTZ »

I might even let him buy it!


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
User avatar
Chad91GTZ
Registered User
Posts: 1354
Joined: Thu Dec 23, 2004 8:32 pm
Location: Lomira, WI

Re: 1996 Z26, born in a barn!

Post by Chad91GTZ »

Damage was pretty severe.

Image

All new!
Image


I got the front end assembled, but took all the pics in 3D and can't post them. Will take new ones. Just gotta find my spare set of Z26 razors and my least crappy set of matching tires and fill her up with gas.

Oh, the fenders were a bitch to line up. The frame is bent on both sides. I can't get the passenger side to line up right now matter what I do. Can't get the door open.


Image
My Motortopia

Bfest Committee 2012, 2013, 2014
Bfest AND Bust 2012 Winner: First ever clutch swap at Berettafest!
Bfest 2013 Watermelon Award: Boob shaped hood dents FTW
Post Reply