3400 top end swap coolant by-pass tube info

Money pit Beretta · Post by **Money pit Beretta** » Sat Sep 10, 2011 6:05 pm

Well my rig job is no longer holding. I cut the end off of my 3100 and used a rubber hose to put on the press in. I have the O ring from GM so that is the right one. I need to know what car to pull the press in tube off of. Or should I just snag one and bend it?

scannerman · Post by **scannerman** » Sat Sep 10, 2011 6:18 pm

i had jut tapped threads in the 3400 intake manifold and used all the stock parts. it worked well for 100k miles.

Money pit Beretta · Post by **Money pit Beretta** » Sat Sep 10, 2011 6:25 pm

That would work great, but the intakes are on the car. Car is down now do to this and I just did the LIMG, so I'm not going to take it off again.

Money pit Beretta · Post by **Money pit Beretta** » Sun Sep 11, 2011 5:59 pm

Well I found a straight tube off of a 2000 big port. Going to have to find a way to bolt it on the head. Damn fuel line holder is in the way. Not sure if the cross over pipe will be in the way.

Beretta.net